Cummins ISB6.7 CM2350 (2013-17) Fault Code: 4152 PID: SPN: 5743 FMI: 9 Aftertreatment Selective Catalytic Reduction Temperature Sensor Module- Abnormal Update Rate - EcuForce Truck (2024)

Table of Contents
Related Related products References

Shop

Account

Cart$0.00

Subtotal: $0.00

No products in the cart.

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 4152 PID: SPN: 5743 FMI: 9 Aftertreatment Selective Catalytic Reduction Temperature Sensor Module- Abnormal Update Rate

Circuit Description
The aftertreatment SCR (selective catalytic reduction) temperature sensor module is a smart device that communicates with the engine control module via the J1939 data link. The aftertreatment SCR temperature sensor module performs its own internal diagnostics and reports malfunctions back to the engine control module using the J1939 data link. The aftertreatment SCR temperature sensor module is used to measure the aftertreatment SCR intermediate temperature and aftertreatment SCR outlet temperature. The temperature probes are permanently attached to the aftertreatment SCR temperature sensor module and can not be replaced individually.

Component Location
The aftertreatment SCR temperature sensor module is mounted on the aftertreatment SCR catalyst.

Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.

Conditions for Setting the Fault Codes
The Engine Control Module (ECM) detected a loss of communication with the aftertreatment SCR temperature sensor module.

Action Taken When the Fault Code is Active
1)The ECM illuminates the amber CHECK ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.
2)Diesel exhaust fluid injection into the aftertreatment system is disabled.
3)Engine torque will be reduced if the engine is operated for an extended period of time with this fault active.

Conditions for Clearing the Fault Code
1)To validate the repair, perform a key cycle, start the engine and let it idle for 1 minute.
2)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
3)The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
4)For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
5)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Possible causes:
1) Low battery voltage supply
2) Incorrect terminating resistance of the SAE J1939 datalink circuit
3) Incorrect sensor for the application (12 VDC versus 24 VDC)
4) Incorrect Battery System Voltage setting in INSITE

Related

Categories Cumminz, ISB6.7 CM2350 (2013-17)Tags 17, 2013, 4152, 5743, 9, Abnormal, Aftertreatment, Catalytic, CM2350, Code, Cummins, Fault, FMI, ISB6.7, Module, PID, Rate, Reduction, Selective, Sensor, SPN, Temperature, Update

Wiring Diagrams

Component Locators

  • download MANCATS II v14.01 2014 Diagnostic software MAN CATS ( virtual machine )

    MAN$75.00

    Rated 0 out of 5

  • Caterpillar CAT ET 2021B Electronic Technician + Factory Password (1PC)

    CAT$75.00

    Rated 0 out of 5

  • Allison DOC 2019 PC software + GEN5 2019 truck

    Allison$40.00

    Rated 0 out of 5

  • JPRO$94.00

    Rated 0 out of 5

  • Volvo Intermediate Storage File Encryptor/Decryptor (Editor) VISFED 0.3.2

    Trucks software$35.00

    Rated 0 out of 5

  • Wabco ToolBox plus 13.7.0.1 + ECAS CAN2 v3.00 Diagnostics Software

    Trucks software$84.00

    Rated 0 out of 5

  • Isuzu IDSS 2021 Diagnostic Software

    ISUZU$100.00

    Rated 0 out of 5

  • Thermo King EPC 2012

    Thermo King$45.00

    Rated 0 out of 5

  • premium volvo tech tool update 2.8.150 diagnostic software 1pc

    Trucks software$150.00

    Rated 0 out of 5

  • download MANCATS II v14.01 2014 Diagnostic software MAN CATS ( virtual machine )

    MAN$75.00

    Rated 0 out of 5

  • Perkins EST 2016C Electronic Service Tool

    Perkins$50.00

    Rated 0 out of 5

  • DETROIT DDDL 8.14 SP3 – Detroit Diesel Diagnostic Link 8.14 SP3 2021 ( 1PC )

    Detroit$73.00

    Rated 0 out of 5

  • volvo delete files 2023 33,46 GB

    Trucks software$300.00

    Rated 0 out of 5

  • Volvo I-Shift service manual PDF

    TRUCK MANUALS$55.00

    Rated 0 out of 5

  • Allison Doc Premium Update 2023 v2

    Allison$102.00

    Rated 0 out of 5

  • Cat Factory Password Generator 1.0 2019 WINDOWS 10

    CAT$55.00

    Rated 0 out of 5

  • 10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C

    CAT$110.00

    Rated 0 out of 5

  • Volvo PROSIS Offline 2019 Parts Catalog Installation Service

    Trucks software$45.00

    Rated 0 out of 5

  • PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks

    PACCAR$60.00

    Rated 0 out of 5

Related products

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3316 PID: SPN:3242 FMI:4 Aftertreatment 1 Diesel Particulate Filter Intake Temperature Sensor Circuit – Voltage Below Normal or Shorted to Low Source

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3254 PID: SPN:3242 FMI:0 Aftertreatment Diesel Particulate Filter Intake Temperature – Data Valid But Above Normal Operating Range – Least Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:324 PID:SID 3 SPN:653 FMI:5 Injector Solenoid Driver Cylinder 3 Circuit – Current Below Normal or Open Circuit

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:325 PID:SID 6 SPN:656 FMI:5 Injector Solenoid Driver Cylinder 6 Circuit – Current Below Normal or Open Circuit

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3261 PID:SID 254 SPN:4342 FMI:5 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 2 Circuit – Current Below Normal or Open Circuit

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3314 PID: SPN:4765 FMI:3 Aftertreatment 1 Diesel Oxidation Catalyst Intake Temperature Sensor Circuit – Voltage Above Normal or Shorted to High Source

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3258 PID: SPN:4340 FMI:5 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 1 Circuit – Current Below Normal or Open Circuit

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3235 PID: SPN:4363 FMI:16 Aftertreatment SCR Outlet Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3241 PID: SPN:4342 FMI:4 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 2 Circuit – Voltage Below Normal or Shorted to Low Source

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3231 PID: SPN:4360 FMI:16 Aftertreatment SCR Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3255 PID: SPN:3246 FMI:0 Aftertreatment Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3321 PID: SPN:3246 FMI:4 Aftertreatment 1 Diesel Particulate Filter Outlet Temperature Sensor Circuit – Voltage Below Normal or Shorted to Low Source

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3251 PID:S326 SPN:4765 FMI:16 Aftertreatment Diesel Oxidation Catalyst Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3256 PID: SPN:3246 FMI:15 Aftertreatment Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Least Severe Level

    DTC TRUCKS

    Rated 0 out of 5

  • PACCAR PX-9 CM2350 (2013-17) Fault Code:3237 PID:SID 254 SPN:4340 FMI:3 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 1 Circuit – Voltage Above Normal or Shorted to High Source

    DTC TRUCKS

    Rated 0 out of 5

  • SERVICE MANUAL BOBCAT 742b-743b sms

    BOBCAT$48.00

    Rated 0 out of 5

  • FUSO$28.00

    Rated 0 out of 5

  • SERVICE MANUAL EATON UltraShift PLUS

    EATON$40.00

    Rated 0 out of 5

  • INTERNATIONAL ENGINES$27.00

    Rated 0 out of 5

  • MANUAL SERVICE DEUTZ AGROPLUS 60-70-80

    DEUTZ$25.00

    Rated 0 out of 5

  • SERVICE MANUAL DETROIT Cooling System – Technicians Guide

    DETROIT$20.00

    Rated 0 out of 5

  • SERVICE MANUAL Carrie Metrobird TDS 115

    CARRIE$25.00

    Rated 0 out of 5

  • FUSO$34.00

    Rated 0 out of 5

  • SERVICE MANUAL DETROIT DD5

    DETROIT$50.00

    Rated 0 out of 5

  • SERVICE MANUAL BOBCAT 430 SMS

    BOBCAT$52.00

    Rated 0 out of 5

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 4152 PID: SPN: 5743 FMI: 9 Aftertreatment Selective Catalytic Reduction Temperature Sensor Module- Abnormal Update Rate - EcuForce Truck (2024)

References

Top Articles
Latest Posts
Article information

Author: Carlyn Walter

Last Updated:

Views: 5936

Rating: 5 / 5 (50 voted)

Reviews: 89% of readers found this page helpful

Author information

Name: Carlyn Walter

Birthday: 1996-01-03

Address: Suite 452 40815 Denyse Extensions, Sengermouth, OR 42374

Phone: +8501809515404

Job: Manufacturing Technician

Hobby: Table tennis, Archery, Vacation, Metal detecting, Yo-yoing, Crocheting, Creative writing

Introduction: My name is Carlyn Walter, I am a lively, glamorous, healthy, clean, powerful, calm, combative person who loves writing and wants to share my knowledge and understanding with you.